Table of Contents
Advertisement
3 The Wizard indicates it will start an interactive procedure to set the
remote addresses correctly.
First, check if the data cables between the computer and all Barco
displays are connected correctly.
When ready, click on Next to continue.
4 Unplug the Remote Out connection of the first display. When ready,
click on Next.
5 Plug in the remote cable into the Remote Out connector of the first
display again.
6 Unplug the Remote Out connection of the second last Barco display.
E.g., if 4 Barco displays are connected, you need to unplug the
Remote Out connection of the 3rd one.
When ready, click on Next.
First installation
43
Advertisement
Table of Contents
