Configuring A Repeater - Avaya Compact DECT Installation Manual

Page 22 - Repeater Installation

Configuring a Repeater

1. Locate and click on the Kirktool icon.
2. Click on Communication and set this to the Comport Setting (serial
3. Select the Repeater tab and click on Residential base. This will change
4. Click on New and enter the required values (only if the Repeater's
5. Click on Write to Repeater.
6. Click on Read from Repeater and check that the values are as required.
7. Click on Exit. You can now use the Repeater.
Page 22
The Repeater Setup Program
– Windows 3.x: Located in the desktop group Kirktool.
– Windows 95/NT:
port) connected to the Repeater.
to CCFP base. Click on Read from Repeater to load the connected
Repeater's current settings. These may be empty.
– CCFP: This is the number of the CDBS. Also ensure that Allow
Subscription has been set to yes (see page 16).
– Base to synchronize on: The base station number (default 1) of the
CDBS with which the Repeater should synchronize or, for repeater
jumps (see page 19), the number of the next repeater nearest to the
CDBS.
– Repeater number: The number for the Repeater.
current settings are empty – see previous step)
– Error messages appear if any values are not correctly set.
You are strongly recommended not to change any other settings
Located in Start | Programs | Kirktool.
38DHB0002UKFH – Issue 5 (27th October 2003)
Compact DECT - Installation Manual