Subscribing To The Survey Base Station - Avaya Compact DECT Installation Manual

Subscribing to the Survey Base Station

Up to eight handsets can be subscribed to the Survey Base Station. All these
handsets can display the RSSI signal quality simultaneously but only one can
receive the audio input at any time. Normally only one handset is subscribed
to the Survey Base Station.
1. Connect the Survey Base Station to it's power supply and switch on.
2. Turn the handset on. Assign it a number between 1 and 8 by dialling
3. Press MENU and the > key until LOGIN appears and then press
4. Press > until SUBSCRIPTION REMOVE appears and then press
5. Enter the password (default 0000) and press
6. You are returned to SUBSCRIPTION CREATE. Press > until
7. When completed, press MENU twice and then press > until LOGIN
8. Press > to display SUBSCRIPTION CREATE and the press
9. Use the < and > buttons to display the ID numbers of available DECT
10. Use the < and > to select which system number you want the Survey
11. SUBSCRIPTION WAIT appears. When successfully subscribed, the
Compact DECT - Installation Manual
38DHB0002UKFH – Issue 5 (27th October 2003)
*99972*x where x is the number between 1 and 8 (each handset must
have a discrete number). Then press
SELECT LOGIN appears. Before subscribing to system, you are
recommended to remove all other subscriptions (steps 4-6).
SUBSCRIPTION REMOVE? Press
System ID (appears below SYSTEM X, where X = 1 to 4). Press
remove.
SUBSCRIPTION REMOVE appears. Repeat from step 4 for all
previously entered System IDs.
appears. Press to display SELECT LOGIN and press
display SYSTEM X, where X = 1 to 4). Use > to select required system
number and press
subscription. The handset is searches for a system to which it can
subscribe. Press and hold the subscribe button on the Survey Base
Station for 3 seconds. The Survey Base Station will then stay in
subscribe mode for one minute.
systems found by the handset. Look for the ID number of the Survey
Base Station (printed on the back of the Survey Base Station) and then
press .
Base Station assigned to and then, at the AC: prompt, enter 1234 (or on
older systems 12345678) and press
handset bleeps. Should SUBSCRIPTION FAILED appear, repeat from
step 8.
.
to display any previously entered
.
.
Site Surveys - Page 9
.
to display
again to
to begin
Using the Site Survey Kit
.
to
Page 9