Table of Contents
Advertisement
Attaching an Directional Aerial
The directional aerial is supplied with a wall mounting plate, screws and wall
fixings. It also includes a 0.9m lead for connection to the directional aerial
socket on the back of the Repeater.
The face of the aerial should be mounted perpendicular to the parent CDBS.
The DECT system should be installed and the position of the Repeater plus
directional aerial tested by making calls before finally fixing the wall mounting
plate into place. The directional aerial then clicks into the wall mounting plate.
The Repeater Setup Program
Before a Repeater can be used, it must be setup with various settings; e.g.
the base station number, system number, etc. The Repeater Setup program
runs on a Windows based PC and require the serial lead and adaptor from a
DECT Repeater Programming kit.
Installing the Repeater Setup Program
The Repeater Setup program is supplied on floppy disks as a self-installing
program. It is also available from the web site
(https://emea-businesspartner.avaya.com/index.asp) as a self-extracting file.
Windows 3.x
1. Insert the first disk.
2. In program Manager, select File and then Run.
3. Type a:\setup.exe and then click on OK.
4. Follow the on-screen instructions for installing the Kirktool program.
Windows 95/NT
1. Insert the first floppy disk.
2. Click on Start. Select Settings and then Control Panel.
3. Select Add/Remove Programs.
4. In the Add/Remove Programs Properties menu click on the
5. Windows will scan the floppy disk for a suitable installation file.
6. When it has located the file setup.exe on the floppy disk, click on Finish.
7. Follow the on-screen instructions for installing the Kirktool program.
Connecting a Repeater for Programming
The Repeater Setup kit includes an adaptor and a programming lead.
1. Use the doubler to connect the serial lead to the Repeater in parallel with
2. Connect the serial lead to the PC on which the Repeater Setup program
Compact DECT - Installation Manual
38DHB0002UKFH – Issue 5 (27th October 2003)
Install/Uninstall tab. Click on the Install button.
The programming lead incorporates special components,
do not use any other serial lead.
the power supply connector. Ensure that the power supply is on.
is installed.
WARNING:
Repeater Installation - Page 21
Page 21
The Repeater Setup Program
Advertisement
Table of Contents
