Table of Contents
Advertisement
Figure 15
AXlink and 12 VDC power
supply wiring diagram
Figure 16
Circuit connector wiring
diagram
Color Active Touch Panels
Using the AXlink 4-pin connector and external 12 VDC power supply
Connect the control system's AXlink connector to the AXlink connector on the rear
panel of the CATP as shown in Figure 15.
PWR(+)
AXP
AXM
GND (-)
Use a 12 VDC power supply when the distance between the control system and
CATP exceeds the limits described in Figure 13. Make sure to connect only the
GND wire on the AXlink connector when using a 12 VDC power supply. Do not
connect the PWR wire to the AXlink connector's PWR (+) terminal on the Control
System side of the connector.
Using the RS-232 (DB9) connector for mouse control or data
The dual-function RS-232 (DB9) connector in the touch panels support most
standard serial mouse control devices and RS-232 communication protocols for PC
data transmission. Refer to Figure 16 for DB9 wiring diagram.
+12VDC
TXD
RXD
GND
Red
+
Black
12 VDC power supply
-
White
Green
Black
Pin 1
2 (TXD)
3 (RXD)
4 and 7 (+12)
5 (GND)
DB-9 connector (male)
PWR
AXP
Control system
AXM
GND
Installing the Touch Panel
15
Advertisement
Table of Contents
