Agilent Technologies 3488 User Manual page 85

•
Note Be sure to select the module, not a port or bit. The options on this menu
are only available when the module is selected.
N 2263A
CONFIG DIO
MODE 1
C O NT P O L P O S
FLA G P O L P O S
I/O P O L P O S
Front-Panel Operation: Select a digital I/O module and press Mode.
"CONFIG DIO" is shown in the display. Press Enter to show the
second-level menu and begin the configuration.
Select a DIO module.
4
Press Mode.
4
Select flow control mode. Press Enter.
4
Select the control line polarity. Press Enter.
4
Select the flag line polarity. Press Enter.
4
Select the I/O direction line polarity. Press Enter.
4
Press Mode again to exit the menu.
Configure a port. Select a digital I/O port, then press Mode, the
CONFIG annunciator lights up. When "DATA POLARITY" appears
in the display, press Enter to set data line polarity and/or use the
knob to select "DISP FORMAT" and press Enter to set data display
format for the port.
DIN
DATA POLARITY
NEG POLARITY
Chapter 4 Features and Functions
or
401
DIN
401
DISP FORMAT
401
BINARY
Digital I/O Operation
4
401
401
401
85
4