Table of Contents
Advertisement
Creating a Scan List
Before initiating a scan, a scan list must be set up. The instrument scans
the specified channels automatically in the same order of the scan list.
•
•
•
Note
Stored states may be used in scan lists. Stored states are discussed in
more detail beginning on page 94.
The scan list is automatically cleared whenever the instrument is
turned off or reset. You can also clear the scan list by pressing
Shift+S.List.
Front-Panel Operation: Press S.List, the CONFIG annunciator will
light. The display will show "ADD TO SCAN". Press Enter to begin
building the scan list. Select each desired channel and press Enter to
add the channel to the scan list. As channels are added, an asterisk is
shown in the display to indicate the channel is a part of the scan list.
ADD TO SCAN
SELECT
*
SELECT
SELECT
Remote Interface Operation: You may use single channels, ranges of
channel, or stored setups in the scan list. Set up a scan list with one
command as follows:
OUTPUT 709; "SLIST 100-109 "! Create a scan list.
10
20
FOR I = 1 to 10
30
OUTPUT 709; "STEP"
40
OUTPUT 709; "DELAY 20"
50
Next I
Chapter 4 Features and Functions
Press S.List. Press Enter.
Select a channel to add.
101
Press Enter.
101
Select the next channel to add.
203
! Step through the scan list.
! Add 20 ms time delay.
Scanning
4
4
79
Advertisement
Table of Contents
