Agilent Technologies 3488 User Manual page 16

STEP 1
1
1. Face the mainframe rear panel toward you.
2. Select a slot in which the module is to be
installed.
STEP 3
(for modules with terminal blocks)
1. Wire the screw terminal block (module
dependent).
2. Attach the screw terminal block to the plug-in
module.
Module installation
16
STEP 2
1. Hold the sides of the module, component side
down, by the metal shields.
2. Insert the module into the slot guides and slide
the module toward the front of the instrument.
3. Push firmly until the module "snaps" into place.
4. Push both plastic levers inward to lock the
module.
STEP 4
(for modules with terminal blocks)
1. Push firmly until the terminal block "snaps" into
place.
2. Secure the screw terminal block with the two
screws (Torque < 8 in-lbs).