Status:questionable:current:enable <Mask> Status:questionable:current:enable - HP E8402A User And Service Manual

STATus:QUEStionable:CURRent:ENABle < mask >
STATus:QUEStionable:CURRent:ENABle?
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
102 Programming the Enhanced Monitor
The
STATus:QUEStionable:CURRent:ENABle
enable register for the CURRent status group.
The STATus:QUEStionable:CURRent:ENABle?
representing the value of the enable register for the CURRent status group.
The enable register specifies which bits in the event register can generate a summary
bit. The instrument logically ANDs corresponding bits in the event and enable
registers, and ORs all the resulting bits to obtain a summary bit. Summary bits are,
in turn, recorded in another register. The Questionable Current Summary bit is
recorded in the Questionable Condition Register. Enable registers are read-write.
Enable registers are not affected by *CLS (Clear status). Querying enable registers
does not affect them.
Name Type Range
< mask > int16 0 - 32767
Type Range
int16 0 - 32767
•
Refer to STATus:QUEStionable:CURRent:CONDition?
each bit in the CURRent status group.
•
If *PSC was set to 0 prior to power-down, then at power-on, the enable
registers are loaded from non-volatile memory. Therefore, any values that you
have stored (SYSTem:NVSave command) are returned to the registers.
However, if *PSC was set to 1, then at power-on the factory defaults are
returned.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-222 "Data out of range"
-241 "Hardware missing"
*RST resets register the last value saved by the SYST:NVS command. Use
to clear the enable registers of the OPERation status group and the
STATus:PRESet
QUEStionable status group.
STATus:QUEStionable:CURRent:CONDition?,
STATus:QUEStionable:CURRent:EVENt?, STATus:PRESet, SYSTem:NVSave,
*PSC
command sets the value of the
Default
487
(see comments
below)
Description
mask value.
The < mask > value is invalid.
Power supply doesn't support current measurements
query returns an integer
Description
Bit mask for the enable register of the
CURRent status group.
for a description of
SYSTem:ERRor?
Probable Cause
query.
Chapter 3