System:nvrecall - HP E8402A User And Service Manual

SYSTem:NVRecall

Comments
Error Conditions
Reset Condition
Related
Commands
Chapter 3
causes the enhanced monitor to reload many of its parameters
SYSTem:NVRecall
from non-volatile memory. This includes temperature limits, current limits, total
power limits, status enable settings, PSC flag, beep frequency, beep duration, system
name, and mainframe serial number. RS-232 settings are not recalled; they are
recalled only at power-on.
•
This command is very similar to
recalled are the last ones saved by the
factory defaults.The commands affected are:
Register
STATus:OPERation:ENABle
STATus:QUEStionable:ENABle
STAT:QUES:BLOWer:ENABle
STAT:QUES:CURRent:ENABle
STAT:QUES:TEMPerature:ENABle
STAT:QUES:VOLT:ENABle
STAT:QUES:VOLT:PTR
STAT:QUES:CURR:LIM
STAT:QUES:TEMP:LIM
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-221 "Settings Conflict"
-311 "Memory Error"
*RST has no effect
SYSTem:NVSave
except that the settings
SYSTem:NVDefault
SYSTem:NVSave
Register
STAT:QUES:POW:LIM
SYST:BEEP:FREQ
SYST:BEEP:TIM
SYST:NAME
SYST:SNUM
HIST:UNIT:TIME
*PSC
*ESE
*SRE
SYSTem:ERRor?
Probable Cause
The mainframe's power is off.
Non-volatile memory is inaccessible.
Programming the Enhanced Monitor
command and not the
query.
149