Figure 6-5 Menu 11.3 - Remote Node Novell Ipx Options - ZyXEL Communications Prestige 128 Plus User Manual

6.5.1 IPX Remote Node Setup
Follow the procedure in Chapter 5 to configure the protocol-independent
parameters in Menu 11.1 - Remote Node Profile. For the IPX-specific parameters
in Menu 11.3 - Remote Node Network Layer Options follow the instructions
below. If you want the Prestige to receive incoming calls, you must also
configure the default dial-in parameters in Menu 13.
To edit Menu 11.3 - Remote Node Network Layer Options shown below, follow
these steps:
In Menu 11.1, make sure IPX is among the protocols in the Route
Step 1.
field. (The Route field should display Route = IPX or Route = IP +
IPX.)
Move the cursor to the Edit IP/IPX/Bridge field, then press the space
Step 2.
bar to select Yes and press [Enter] to open Menu 11.3 - Network
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Layer Options.

Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options

IPX Configuration
Prestige 128+ ISDN Router
Menu 11.3 - Remote Node Network Layer Options
IPX Options:
Dial-On-Query= No
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
Bridge Options:
Enter here to CONFIRM or ESC to CANCEL:
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
6-7