Additional Installation Requirements - ZyXEL Communications Prestige 128 Plus User Manual

Connecting the Power Adapter to your Prestige
Step 3.
Connect the power adapter to the port labeled POWER on the rear panel of your
Prestige.
Connecting the Console Port
Step 4.
For the initial configuration of your Prestige, you need to use a terminal emulator
software on a workstation and connect it to the Prestige through the console port.
Connect the 9-pin (smaller) end of the console cable to the console port of the
Prestige and the 25-pin (bigger) end to a serial port (COM1, COM2 or other
COM port) of your workstation. You can use an extension RS-232 cable if the
enclosed one is too short.
After the initial setup, you can modify the configuration remotely through telnet
connections. See Chapter 14 - Telnet Configuration and Capabilities for
detailed instructions on using telnet to configure your Prestige.
2.3

Additional Installation Requirements

In addition to the contents of your package, there are other hardware and
software requirements you need before you can install and use your Prestige.
These requirements include:
1. A computer with Ethernet 10Base-T NIC (Network Interface Card).
2. A computer equipped with communications software configured to the
following parameters:
♦ VT100 terminal emulation.
♦ 9600 Baud.
♦ No parity, 8 Data bits, 1 Stop bit.
After the Prestige is properly set up, you can make future changes to the
configuration through telnet connections.
Hardware Installation and Setup
Prestige 128+ ISDN Router
2-5