ZyXEL Communications Prestige 128 Plus User Manual page 23

Prestige 128+ ISDN Router
System Name - This is the name given to the Prestige for identification purposes.
This name should be no more than eight alphanumeric characters. Spaces are not
allowed, but '-' and '_' are accepted.
You have now collected all of the general setup information you need. Please
make sure that you have entered all the values onto the worksheet before
proceeding to the next section.
Collecting ISDN Phone Line Information
Once your ISDN line is installed by the telephone company, you need to use the
following information to complete the worksheet and configure your Prestige.
Much of this information is provided by your telephone company upon
installation of the ISDN line.
Switch Type - This is the type of switch used by your telephone company.
Check with your telephone company and choose the appropriate option on the
worksheet.
B Channel Usage - Determine which connection is appropriate for your B
channel and check the corresponding option on the worksheet. If your Prestige is
the only device using the ISDN line, then configure B Channel Usage to
Switch/Switch so that your Prestige will use both B channels to communicate.
If your Prestige is sharing the ISDN line with other devices, then configure B
Channel to Switch/Unused.
Telephone Number(s) - Record on the worksheet the telephone number(s) given
to you by your telephone company. Some switch types only have one telephone
number. The Prestige only accept digits; '-' and spaces are not allowed.
Analog Call - Check the appropriate Analog Call option on the worksheet for
each telephone number. This information is later used to configure the Prestige in
routing an incoming analog call. Set to Phone1 or Phone2 if you wish to route
the incoming analog call for this telephone number to PHONE port number 1 or
2.
Preface xxiii