Applying An Ip Policy; Ethernet Ip Policies - ZyXEL Communications Prestige 652H series User Manual
Adsl security/wireless lan router
Hide thumbs
Also See for Prestige 652H series:
- User manual (523 pages) ,
- Compact manual (36 pages) ,
- Brochure (2 pages)
Table of Contents
Advertisement
FIELD
Precedence
Packet Length
Len Comp
Source:
addr start / end
port start / end
Destination:
addr start / end
port start / end
Action
Gateway addr
Type of Service
Precedence
Log
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
41.5 Applying an IP Policy
This section shows you where to apply the IP policies after you design them.
41.5.1 Ethernet IP Policies
From Menu 3 — Ethernet Setup, type 2 to go to Menu 3.2 — TCP/IP and DHCP Ethernet Setup.
IP Policy Routing
Table 41-2 Menu 25.1.1 IP Routing Policy
Precedence value of the incoming packet. Press [SPACE BAR] and then [ENTER] to
select a value from 0 to 7 or Don't Care.
Type the length of incoming packets (in bytes). The operators in the Len Comp (next
field) apply to packets of this length.
Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, Less,
Greater, Less or Equal or Greater or Equal.
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not Matched.
Defines the outgoing gateway address. The gateway must be on the same subnet as
the Prestige if it is on the LAN, otherwise, the gateway must be the IP address of a
remote node. The default gateway is specified as 0.0.0.0.
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic by
choosing No Change, Normal, Min Delay, Max Thruput, Max Reliable or Min
Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or No Change.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the system
log when a policy is executed.
Prestige 652H/HW Series User's Guide
DESCRIPTION
41-5
Advertisement
Table of Contents
Troubleshooting
