29.1 Remote Node Setup Overview
This section describes the protocol-independent parameters for a remote node. A remote node is required for
placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind
it across a WAN connection. When you use menu 4 to set up Internet access, you are configuring one of the
remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that node's profile in
menu 11.1, as well as configure specific settings in three submenus: edit IP and bridge options in menu 11.3;
edit ATM options in menu 11.6; and edit filter sets in menu 11.5.
29.2 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
29.2.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
Step 2.
When menu 11 appears, as shown in the following figure, type the number of the remote node
that you want to configure.
Remote Node Configuration
Remote Node Configuration
This chapter covers remote node configuration.
Prestige 652 Series User's Guide
Chapter 29
29-1