Introduction To Vlans; Table 25-2 Tcp/Ip Ethernet Setup - ZyXEL Communications Prestige 652H series User Manual

Prestige 652H/HW Series User's Guide
FIELD
Remote DHCP Server If Relay is selected in the DHCP field above then enter the IP
Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port.
FIELD
TCP/IP Setup
IP Address Enter the (LAN) IP address of your Prestige in dotted decimal
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on
RIP Direction Press [
Version
Multicast
IP Policies
Edit IP Alias

25.4 Introduction to VLANs

A VLAN (Virtual Local Area Network) allows a physical network to be partitioned into multiple logical
networks. Devices on a logical network belong to one group. A device can belong to more than one group.
With VLAN, a device cannot directly talk to or hear from devices that are not in the same group(s).
25-4
Table 25-1 DHCP Ethernet Setup
address of the actual remote DHCP server here.

Table 25-2 TCP/IP Ethernet Setup

notation
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the Prestige.
SPACE BAR
] to select the RIP direction. Choices are Both,
In Only, Out Only or None.
SPACE BAR]
Press [
RIP-2B or RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
SPACE BAR]
Press the [
disable it.
Create policies using SMT menu 25 (see the IP Policy Routing
chapter) and apply them on the Prestige LAN interface here. You
can apply up to four IP Policy sets (from twelve) by entering their
numbers separated by commas.
The Prestige supports three logical LAN interfaces via its single
physical Ethernet interface with the Prestige itself as the gateway for
each LAN network. Press [
ENTER
press [ ] to display menu 3.2.1.
DESCRIPTION
DESCRIPTION
to select the RIP version. Choices are RIP-1,
to enable IP Multicasting or select None to
SPACE BAR
] to change No to Yes and
EXAMPLE
EXAMPLE
192.168.1.1
255.255.255.0
Both
(default)
RIP-1
(default)
None
(default)
2,4,7,9
No
(default)
Menu 3 LAN Setup