Wall Jack
2.6
Turning On Your Prestige
At this point, you should have connected the ADSL line, the Ethernet port and the power port to the
appropriate devices or lines. You can now turn on the Prestige by pushing the power button on. Refer to the
Read Me First for instructions on setting up your computer. The following procedure details how to telnet
into your Prestige.
Step 1.
In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.1" (the default IP address) and click OK. The Prestige should already be on when
you turn on your computer, see the Read Me First for details.
Step 2.
Entering the password
The login screen appears prompting you to enter the password, as shown below.
For your first login, enter the default password 1234. As you type the password, the screen displays an (X)
for each character you type.
Please note that if there is no activity for longer than 5 minutes after you log in, your Prestige will
automatically log you out. You will have to telnet into the Prestige again.
Hardware Installation & Setup
Y -CONNECTOR
Figure 2-4 Connecting the Microfilter
Enter Password : XXXX
Figure 2-5 Login Screen
Prestige 645 ADSL Internet Access Router
Prestige
Microfilter
Wall
Phone
Side
Side
2-5