Drum Track
Drum Track does not start
Is the DRUM TRACK ON/OFF switch turned on (lit)?
Is the DRUM TRACK [ON/OFF] switch blinking?
Trigger Mode is set to Wait KBD Trig. The drum track
pattern will start when you play the keyboard or
receive a note‐on. See "Turning the Drum Track on and
off" on page 240.
Does the current Drum Track pattern contain data? If
there's no data in the pattern, the Drum Track won't
play.
If you're in Combination mode, is the Output Channel
setting appropriate? See "Using the Drum Track in
Combination mode" on page 240.
Vector
Can't control the volume
Is the Enable Volume Control check box checked?
Is the Combination or Sequencer mode VJS Assign
setting appropriate?
Have you checked the Enable Program Vector Volume
check box so that the volume control of a program can
be reproduced in Combination or Sequencer mode?
CC control does not work
Is the Enable CC Control check box checked?
Are the VJS X mode and VJS Y mode settings
appropriate?
Drum Kits
The drum sample's pitch does not change
You have left the Assign check box unchecked, and
want to play the drum sample at the adjacent right a
semitone lower, but the pitch does not change.
Wave Sequences
The wave sequence does not advance
Is the Run check box checked?
Swing does not work properly
Is the wave sequence's Mode set to Tempo?
Is the wave sequence's Swing Resolution set
appropriately?
Troubleshooting Drum Track
If you're in Sequencer mode, are the Input Channel
and Output Channel settings appropriate? See "Drum
Track settings in Sequencer mode" on page 242.
Is the MIDI Clock parameter set correctly? See "MIDI
Clock synchronization" on page 160.
In the Global P0: Basic Setup page, is All KARMA/DT
Off checked? See "Globally disabling KARMA and the
Drum Track" on page 159.
If the Drum Track stops when you switch the KARMA
Master scene, have you checked the DT Run (Drum
Track Run) check box of the KARMA Master scene?
In Combination or Sequencer mode, are the Enable
Combi Vector CC or Enable Song Vector CC check
boxes checked?
Have you checked the Enable Program Vector CC
check box so that the CC control of a program can be
reproduced in Combination or Sequencer mode?
An envelope doesn't operate according
to its settings
Is the front panel vector joystick set to the center
position? The operation of the envelope is offset by the
position of the vector joystick.
• Hold down the RESET CONTROLS button and
move the vector joystick to reset it to the center.
• If you have selected a drum program in Program
mode, and then want to edit the drum kit in Global
mode, go to the Program P2: Edit‐Pitch, OSC1 Pitch
Mod. page and set Pitch Slope to +1.0 before you
enter Global mode.
253