Korg Kronos Operation Manual page 106

Creating songs (Sequencer mode)
Listen to the recorded result
10.In the P0: Play/REC– Audio TRACK Mixer page,
mute the playback of both audio tracks 1 and 2.
Play/Rec/Mute: Mute
Solo On/Off: Off
11.Press the SEQUENCER START/STOP switch to
play back the song.
Make output settings for audio track 3 as described
in "Listen to the recorded result" on page 96.
12.Press the SEQUENCER START/STOP switch to
stop playback.
If you want to create a WAVE file on the disk from a
song that includes audio tracks, see "Resampling a
song to create a Wave file" on page 152.
Recording automation events for pan,
EQ, and volume etc. on an audio track
All audio track parameters (Pan, Volume, Send1/2,
and EQ) can be recorded in realtime. In this example,
we'll record Pan and Volume changes on audio track 3.
Go to the P0: Play/REC– Audio Track Mixer page, and
use "Track Select" to select Audio Track 03 as the track
to be recorded. You could use the VALUE controller to
operate a desired parameter, but using the control
surface lets you mix up to eight tracks simultaneously.
Setup
1. Go to the P0: Play/REC– Preference page.
2. In Recording Setup, Recording Setup (Audio
Track), choose the desired recording method.
In this example, we'll choose overdub recording so
that we can record repeated passes, adding more
automation data on each pass.
– Recording Setup –
Overdub: on
– Recording Setup (Audio Track) –
Automation Only: checked
If you record without checking "Automation Only,"
audio events will also be recorded. Note that this
will erase and overwrite the audio events that
already exist.
3. Go to the P0: Play/REC– Control Surface page.
100
4. Press the CONTROL ASSIGN AUDIO switch
several times so that the HDR1–8 LED located at
the right of the switch is lit.
5. In the center of the right edge of the LCD, check
"Link KBD REC Trk to Ctrl Surface."
If you check this and press the MIX SELECT 3
switch, each knob will control audio track 3, and at
the same time "Track Select" will switch to Audio
Track 03.
Press the SEQUENCER START/STOP switch to play
back, and operate the knobs and sliders etc. to
rehearse your mix.
If MIXER KNOB is set to CHANNEL STRIP, knob 1
will control pan, knobs 2–6 will control EQ, and
knobs 7 and 8 will control the send levels. Use slider
3 to adjust the volume of audio track 3.
When you've finished rehearsing, press the
SEQUENCER START/STOP switch to stop.
Press the LOCATE switch.
Record
6. Press the SEQUENCER REC/WRITE switch.
The metronome will begin sounding, and you will
be in record‐ready mode.
7. Press the SEQUENCER START/STOP switch.
After a two‐measure count, recording will begin.
Use the sliders etc. to control the volume.
Note: When recording automation events, you can
use quantization, the resolution setting, and the
compare function in the same way as for a MIDI
track.
8. When you're finished recording, press the
SEQUENCER START/STOP switch to stop
recording.
9. Listen to the recorded result.
Press the SEQUENCER START/STOP switch to play
back.
If you want to record again, use the Compare
function (press the COMPARE switch) to re‐record.
10.If you want to continue adding automation events,
repeat the recording procedure from step 6.