Korg Kronos Operation Manual page 38

Playing and editing Programs
Each Program, Combination, and Song stores its own
settings for what the switches will do, and whether
each switch is on or off (based on their current states
when the Program, Combination, or Song is saved).
You can also make settings for Sampling mode as a
whole.
In Program mode, you can check the assignments of
SW1 and SW2 on the Play page Assignment tab.
In all modes, you can edit the assignments for SW1/2
on the Set Up Controllers page.
Programs (HD-1 and EXi)
Combinations and Songs
Sampling mode
When using SW1/2 for AMS or Dmod, the default
settings are SW1 Mod.:CC#80 and SW2 Mod.:CC#81.
For an example, see "Using Dmod to change the
feedback level via SW1" on page 209. For a complete
list of the possible assignments, see "SW1/2
Assignments" on page 1104 of the Parameter Guide.
Note: If you wish to keep these settings after the power
is turned off, you must save the Program,
Combination, or Song. Settings for Sampling mode
cannot be saved.
An example of settings in a Program
Using the Lock function
Locking the Joystick
1. Using the factory sounds, select Program INT‐
B044: Real Suit E.Piano, and play the keyboard.
2. Move the joystick away from yourself (the +Y
direction).
The vibrato effect will deepen.
3. While holding the joystick away from yourself,
press the SW2 switch.
When you press the switch, its LED will light up,
and the modulation effect at this point will be
maintained.
32
P1: Basic/Vector
P1: EQ/Vector/Controller
P4: EQ/Controller
4. Release the joystick, and play the keyboard.
The modulation will stay the same as it was when
SW2 was pressed. Moving the joystick away from
yourself will not affect the sound.
5. Press the SW2 key once again to release the Lock
function.
Locking the Ribbon Controller
1. Select Program INT‐B044: Real Suit E.Piano.
2. Press the SW2 key.
The LED on SW2 will light up.
3. Touch the ribbon controller, and move your finger
left and right.
Movement in the +X direction will brighten the tone,
and movement in the –X direction will darken the
tone.
4. Lift your finger up from the ribbon controller.
The sound will remain as it was when you last
touched the ribbon.
5. Press the SW2 key once again to release the Lock
function.
6. Press the tab labeled Cntrl/View Effect, to go to the
Controller/View Effect page.
In the upper right‐hand portion of the screen, notice
that SW2 is assigned to JS Y & Ribbon Lock, and is set
to Toggle. This means that SW2 is assigned to control
the Lock function for both the joystick's Y axis and the
ribbon controller. Many Programs and Combinations
use this assignment.
You can also lock both the ribbon and the joystick at
the same time:
1. Move the joystick in the +Y direction
2. Press the SW2 key to turn on the Lock function.
3. Move your finger on the ribbon controller.
4. Release the joystick, and lift your finger up from
the ribbon.
The effects of both the ribbon and the joystick will be
maintained until you press SW2 again to release the
lock.
Lock can also be applied to aftertouch, by assigning
SW1 or SW2 to After Touch Lock.
For details on the functions that you can assign to SW1
and SW2, please see the "SW1/2 Assignments," on
page 1104 of the Parameter Guide.