Korg Kronos Operation Manual page 103

Note: You can use functions such as Compare when
recording audio events, just as you can when
recording MIDI tracks.
Note: If you want to apply an insert effect on an
audio track, set Bus Select (IFX/Indiv. Out Assign)
to IFX1–IFX12.
Then select L/R as the Bus Select setting (P8: Insert
Effect– Insert FX page) that follows the insert effect
you used.
Note: If you want to apply master effects to an audio
track, use Send1 (MFX1) and Send2 (MFX2) to set
the send levels to the master effect. If you're using
an insert effect, adjust the Send1 and Send2 settings
that follow that insert effect.
Recording an external input source on audio
track 2 while you listen to the previously-
recorded audio track 1
In this example, we'll record another guitar
performance on audio track 2 while monitoring the
performance you previously recorded on audio track 1
as described in "Recording an external input on audio
track 1."
1. In the P0: Play/REC– Audio Track Mixer page, set
the Audio Input 2 REC Source to Audio Input 1 (In
1).
AUDIO TRACK 2 REC Source: Audio Input 1 (In 1)
2. Set Track Select to Audio Track 02.
3. Record as described in step 8 and following of the
preceding section.
Applying an insert effect while you
record
In this example, we'll apply an insert effect to the
guitar that's connected to Audio Input 1, and record
the effect‐processed sound on audio track 1.
Connect your guitar
1. Connect your guitar.
For detailed instructions, see "Recording an external
input on audio track 1" on page 95.
Setup
2. In the P0: Play/REC– Audio Input/Sampling page,
set the "Audio Input" parameters as shown below
that the signal from the AUDIO INPUT 1 jack is
sent to IFX1.
Use Global Setting: Off
Bus Select (IFX/Indiv.): IFX1
INPUT1 Level: 127
INPUT1 Pan: L000
INPUT1 REC Bus: Off
Audio recording Recording procedure
3. In the P8: Insert Effect– Insert FX page, select the
desired effect and route it to REC bus 1.
IFX1 On/Off: On
IFX1: the desired effect
Bus Sel.: Off
REC Bus: 1
4. In the P0: Play/REC– Audio Track Mixer page, set
REC Source to REC1 so that the signal of the REC
bus will be recorded on audio track 1.
Audio Track 1 REC Source: REC1
97