Trigger: Sequencer START SW
Press the SAMPLING REC switch and START/STOP
switch to enter record‐standby mode. Then press
the SEQUENCER START/STOP switch to start
recording.
Save to: Disk
The sample will be saved to the disk, directory, and
file name specified in Select Directory/File for
Sample to Disk.
Mode: Stereo
The sound of the internal L/R channels will be
sampled in stereo.
7. Use the page menu command Select Directory/File
for Sample to Disk to set the disk. directory, and
file name for the WAVE file.
Use Drive Select and the Open and Up buttons to
select the directory in which the WAVE file will be
saved.
Press the text edit button to go to the text edit dialog
box, and enter a filename.
Leave Take No. checked. The number at the right of
Take No. will be input as the last two characters of
the filename.
This number will increment each time you sample,
ensuring that the filename will not be the same even
if you sample repeatedly.
After you have made the settings, press the Done
button to close the dialog box.
8. Set Sample Time to the length that you want to
sample.
Set this to a value slightly greater than the length of
the song.
9. Set the Sample to Disk parameter to the desired
bit depth.
You can sample to disk at either 16‐bit or 24‐bit
resolution.
10.Set the recording level.
Press the SAMPLING REC switch.
Note: It will take between several seconds to nearly a
minute from the moment you press the SAMPLING
REC switch until the KRONOS enters standby mode
(i.e., until the SAMPLING REC switch changes from
blinking to lit). This time is required in order to
allocate sufficient space on the disk.
Press the SEQUENCER START/STOP switch to play
back the song, and adjust the sampling volume
while you watch the level meters. The default
setting is 0.0 dB. If the level is too low, use the
VALUE controller to raise the level as high as
possible without causing the "CLIP !" indicator to
appear.
When you finish making adjustments, press the
SAMPLING REC switch.
Press the SEQUENCER START/STOP switch to stop
the song playback. Then press the LOCATE switch.
11.Start sampling.
Press the SAMPLING REC switch and then the
SAMPLING START/STOP switch to enter
recording‐standby mode.
Sampling in Sequencer mode Resampling a song to create a Wave file
Press the SEQUENCER START/STOP switch to play
back the song. Sampling will begin at the same time.
When the song finishes playing back, press the
SAMPLING START/STOP switch to stop sampling.
Use the page menu command Select Directory/File
for Sample to Disk to verify that the WAVE file was
created. Select the file and press the SAMPLING
START/STOP switch to listen to the sound that was
sampled.
153