JUKI IP-110 Instruction Manual page 27

Explanation of displayed information and operating switches on the pitch time monitor screen
No. 1 (pitch time graph mode)
No. Item to be set
A Pitch time graph display
B Cursor display
C Continuous section display
D Cursor pitch time display
E Display of the production volume in
a cursor secton
F Latest pitch time display
Producton volume count-up swtch The producton volume s counted up wth one tem added.
1
Functon selector swtch
2
Functon shftng swtch
3
Graph scroll swtch
4
Display changeover switch to
5
display the pitch time monitor
screen No. 2
Producton volume counter
6
correcton swtch
A graph vertical axis of which represents the production volume and
horizontal axis of which represents the pitch time is displayed.
The ranges of the vertical and horizontal axes can be set on the pitch time
montor screen No. 2.
The location of the cursor is displayed.
The continuous section set on the graph is displayed.
The total producton volume and average ptch tme n a contnuous secton
selected on the pitch time monitor screen No.2 can be checked.
The pitch time in the section specified by the cursor on the graph is
displayed.
The production volume in the section specified with the cursor on the graph
is displayed.
The length of tme between two tmes of thread trmmng s measured and
displayed.
* If the ptch tme s equal to or longer than 1800 seconds (30 mnutes), t
will be regard as defective data and ---- will be displayed instead of the
ptch tme.
The cursor or the contnuous secton selecton (begnnng and end) s
selected.
Selected functon s shfted to the rght or left.
When this switch is pressed shortly, the graph is scroll to the right or left by
one secton.
When this switch is held pressed for a longer time, the graph is scrolled to
the right or left on a page-by-page basis.
The pitch time monitor screen No. 2 is displayed.
The production volume can be corrected by increasing/decreasing the
number shown on the counter n ncrements of 1.
– 25 –
Descrpton