Setting Common Data For The Production Support Function; ProductOn Support Common SettNg Screen No. 1 - JUKI IP-110 Instruction Manual

2-6. Setting common data for the production support function

Refer to "!. 2-2 Information
*
Items commonly applied to each production support function are set on the production support common
settng screens No. 1 and No. 2.
(1) Production support common setting screen No. 1
Input data on tems 1 to 5 referrng to the table gven below.
When Enter swtch 6 is pressed, the input data is confirmed. When Cancel swtch 7 s pressed, the
nput data s cancelled and the screen s restored to the prevous screen.
No. Item to be set
Acceptable number of
1
sttches for count-up
The number of tmes of
2
thread trmmng per count
Enable/disable of count by
3
thread trmmng
Display method selector
4
swtch
Restng status
5
mode" for the operating procedure to be taken until this screen is displayed.
1
3 4 5
2
1 3 4 5
2
When the sewing machine stops after thread trimming and the number of sewn
sttches exceeds the preset number of sttches, an nput of the count-up of
producton volume s accepted.
Settng range : 0 - 99
* Input of the producton volume count-up :
Producton volume count-up swtch and the optonal producton management swtch
input, displayed on each production support screen under the normal sewing mode.
Ths settng s used for preventng ncorrect nput or fraudulent nput.
The number of tmes of thread trmmng per count on the producton volume counter
s set.
Settng range : 1 - 999
* This setting is used in the case of automatic count up by the thread trimming
operaton wthout usng the producton volume counter.
Enable/disable of the automatic count-up of the production volume counter and the
quantity of sewn items counter.
Enable Dsable
* When this item is set to the enable, the number of times of thread trimming
descrbed n 2 s referred.
The unit employed to display the time data on each production support function
screen s set.
: Displayed in second
Initial setting : Displayed in second
On each producton support functon screen, the measurement of the operatonal
status of the sewing machine and recording of data can be temporarily halted. This
halt status s set.
Measurement s at halt :
Measurement s at halt and startng of the sewng machne s prohbted :
– 18 –
Cancel switch 7
Enter switch 6
Descrpton
Intal value : 0
Intal value : 1
Intal settng : Dsable
: Displayed in minute