JUKI IP-110 Instruction Manual page 25

Explanation of displayed information and operating switches on the pitch time monitor screen
No. 1 (production volume graph mode)
No. Item to be set
A
Production volume graph display
B
Cursor display
C
Continuous section display
D
Cursor time of day display
E
Display of the production volume in a
cursor secton
F
Latest pitch time display
Producton volume count-up swtch
1
Functon selector swtch
2
Functon shftng swtch
3
Graph scroll swtch
4
Display changeover switch to display
5
the ptch tme montor screen No. 2
Producton volume counter correcton
6
swtch
A graph vertical axis of which represents the production volume and
horizontal axis of which represents the working time of day is displayed.
The ranges of the vertical and horizontal axes can be set on the pitch
tme montor screen No. 2.
The location of the cursor is displayed.
The continuous section set on the graph is displayed.
The total producton volume and average ptch tme
n a contnuous secton selected on the ptch tme montor screen No.2
can be checked.
The time of day for the section specified with the cursor on the graph is
displayed.
The production volume in the section specified with the cursor on the
graph is displayed.
The length of tme between two tmes of thread trmmng s measured
and displayed.
* If the ptch tme s equal to or longer than 1800 seconds (30
minutes), it will be regard as defective data and ---- will be displayed
nstead of the ptch tme.
The producton volume s counted up wth one tem added.
The cursor or the contnuous secton selecton (begnnng and end) s
selected.
Selected functon s shfted to the rght or left.
When this switch is pressed shortly, the graph is scroll to the right or left
by one section.
When this switch is held pressed for a longer time, the graph is scrolled
to the right or left on a page-by-page basis.
The pitch time monitor screen No. 2 is displayed.
The production volume can be corrected by increasing/decreasing the
number shown on the counter n ncrements of 1.
– 23 –
Descrpton