Weider Platinum Plus 831.15407.0 User Manual page 7

2, 2
insert two M14 x 155mm Bolts (107) through the
Right Arm Frame (171) and the Upright Base (2),
Hand tighten two M14 Nylon Locknuts (127) onto
the Bolts,
insert two MIO x 65mm Carriage Bolts (103) up
through the Base (1), Place a piece of tape over
the BoJt heads to hoJd them in pJace. Connect
the Upright Base (2) to the Base with the two
Carriage Bolts and two MIO Nylon Locknuts
(112), Do not tighten these Locknuts yet.
Connect the Upright Base (2) to the Base (1) with
two MIO x 67mm Bolts (111) and two MIO Nylon
Locknuts (112), Fully tighten these Locknuts.
Set the Mech Frame (124) onto the Base (1)
behind the Upright Base, Hand tighten two MIO x
73mm Screws (137) and two MIO Washers (129)
into the indicated holes in the Base and Mech
Frame, Note: The Mech Frame wHI not be
shown in the following drawings for clarity.
Note: One end of the Rope (70) is connected
to the Right Arm Frame (171). Untie the loose
end of the Rope and route it through the Upright
Base (2), Make sure the loose end of the Rope
is stH[ between the 90ram Thin Pulley (88) and
CabJe Trap (78} (see the inset drawing), and
that it crosses under the connected end of the
Rope.
1O7
2
171
107 2
\
7127
112
..'" 111
124
137
%/
129
7