Weider Platinum Plus 831.15407.0 User Manual page 19

ADJUSTING THE SQUAT ARM
To adjust a Squat Arm (18), puHH the Arm to the
desired position,
ADJUSTING THE BACKREST
The Backrest (24) can be used in a HeveH position or an
inclined position, To use the Backrest in a HeveH posi-
tion, secure the Seat Carriage (16) at the adjustment
helle in the Rail (5) cHosestto the Front Leg (not shown)
(see ADJUSTHNG THE SEAT on the next page),
To use the Backrest (24) in an inclined position,
secure the Seat Carriage (16) at one of the other
adjustment holies in the Rail (5), Rest the Backrest
against the Upright Base (2) or the Upright (3), Note:
To use the Backrest in the most inclined position,
the Squat Pin (not shown} must hold the Squat
Carriage (not shown} in the highest position (see
ATTACHING THE SQUAT STATION below}.
For row exercises, remove the Backrest Frame (17)
from the Seat Carriage (16) HoHdthe Backrest Frame
verticaHHy over the Seat Carriage and Hiltthe rod out of
the shot (see the inset drawing),
ATTACHING THE SQUAT STATION
To use the squat station, first remove the backrest
(see ADJUSTHNG THE BACKREST above), Next,
adjust the squat arm to the forward position (see
ADJUSTHNG THE SQUAT ARM above), Then, insert
a Squat Pin (35) into the correct hoHein the Upright
(3), FinaHHy, attach each end of the Rope (70) to the
Squat Carriage (10) with an Extension Strap (82) and
two CaMe CHips(161),
Note: The Squat Pin (35} will determine the towest
point to which the Squat Carriage (!0) can
descend. The Squat Carriage shouJd not be able to
descend so low that the user couJd become
trapped under the Squat Arms (!8}.
18
5 16
82
\
24
//
/
Ji
61
18
18
82
19