Weider Platinum Plus 831.15407.0 User Manual page 13

18, Press the Front Leg Foot (38) onto the Front Leg
(4), Note: The front of the Front Leg Foot is
tatter than the back of the Foot.
Attach the Front Leg (4) to the Rail (5) with four
M8 x 20mm Screws (95) and four M8 Washers
(152),
19, Pull out the Seat Knob (138) as far as it will go,
and set the Seat Carriage (16) on the Bench Rail
(5),
Loosely attach two 8mm Spacers (123), a 59mm
Spacer (122), and two Seat Wheels (74) to the
bottom holes in the Seat Carriage (16) with an
M8 Nylon Jamnut (139) and an M8 x 102mm Bolt
(119), Make sure the parts are oriented as
shown in the inset drawing.
20, Make sure that the wide sides of aH six Seat
WheeJs (74) are pressed against the Rail (5).
While a second person presses down on the Seat
(25), hoUdthe bottom Seat WheeUs firmUy against
the bottom of the Rail and properly tighten the
indicated M8 NyUonJamnut (139), Do not over-
tighten the Jamnut; the Wheels must be able
to roll across the Rail.
Engage the Seat Knob (138) into an adjustment
hole in the Rail (5),
18
19
95
95
152'
\
5
Front is
taller __
119
123
Side
74-
25
5-
74 74 139 138
13