Weider Platinum Plus 831.15407.0 User Manual page 20

ADJUSTmNG THE SEAT
The Seat (25) can be secured at various positions on
the Rail (5). To move the Seat, pull the Seat Knob
(138) out as far as it wHU go and slide the Seat to the
desired position. Engage the Seat Knob into an
adjustment hoUein the Rail.
To perform row exercises, the hip strap must be
attached to the rope (see ATTACHING THE ACCES-
SORES on page 18), and the Seat Carriage (16)
must be aMe to roll aUongthe Rail (5). First, remove
the backrest from the seat carriage (see ADJUSTUNG
THE BACKREST on page 19). Then, pull the Seat
Knob (138) out as far as it wHU go, and turn the Seat
Knob so that the pin rests at the end of the "L'-
shaped sUot(see the inset drawing).
STORING THE RESISTANCE SYSTEM
To store the resistance system, first remove the CurU
Pad (not shown) and the Leg Lever (not shown) from
the resistance system. Secure the Seat (25) at the
position cUosestto the Front Leg (4) (see ADJUSTUNG
THE SEAT above). Next, remove the Storage Knob
(44) from the Upright Base (2). Lift the Front Leg
toward the Top Frame (20). Tighten the Storage Knob
into the side of the Upright Base and into the Rail (5).
To move the resistance system, stand behind the
Upright (3) and place the toe of your shoe on the end
of the Base (1). Tilt the resistance system back onto
the Wheels (49) and roll it to the new location.
Storage Knob (44} !s !a place and fully tight_
ened each time the resistance system is used.
25
Hole
25
\
Pin 138
49
1
2O