12. Wet a Squat Arm (18) and the inside of a Small
Foam Pad (36) with soapy water. Slide the Foam
Pad onto the Squat Arm.
Grease an M10 x 73mm Bolt (137). Attach a
Squat Arm (18) to the Squat Carriage (10) with
the Bolt, two 24mm Plastic Washers (110), and
an M10 Nylon Loeknut (112). Do not overtighten
the Locknut; the Squat Arm should
be able to
pivot with intermediate
effort.
Repeat this step with the other Squat Arm
(18).
13, Orient the Top Frame (20) with the mark in the
position shown, Attach the Top Frame to the
Upright (3) with two MIO x 65mm Sutton Screws
(117) and two MIO Washers (129), Press the
Plastic Cap (46) into the Upright, over the Top
Frame,
14, Attach the Upright Hate (23) to the Upright (3)
with six M4 x 9mm Self-tapping Screws (106),
12
13
14
137
Grease
18
J
110 /
112
20
Mark
46
106
106
18
11