15, Attach the Console (21) to the Upper Wire
Harness (172), The connector
should slide easi-
ly into the socket and snap into place. If a con-
nector does not slide easily and snap into place,
turn it over and then insert it, IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON. Push the excess wire into the
Upright (3),
Attach the Console (21) to the Upright (3) with
two M4 x 80mm Self-tapping Screws (145), two
M4 x 65mm Self-tapping Screws (158), and four
M4 Washers (157),
16. Odent the Rail (5) with the holes on the side
shown. Attach the Rail to the Upright Base (2)
with an MIO x 106mm Bolt (19) and an MIO
Nylon Locknut
(112). Do not overtighten
the
Locknut;
the Rail must
be able to pivot
easily.
Tighten the Storage
Knob (44) into the
Updght
Base (2) and the Rail (5).
17. Orient the Seat (25) as shown, Attach the Seat to
the Seat Carriage (16) with four M6 x 16mm
Screws (108),
15
16
17
Attach at
this hole
5
Holes
\
157
/
44 //
Wide
End
157
145
108
108
158
25
12