Weider Platinum Plus 831.15407.0 User Manual page 10

10, Press the Front Cover (31) onto the Upright Base
(2), Make sure the Cover is oriented as shown
in the inset drawing.
Route the Upper Wire Harness (172) down
through the Upright Base (2) and out the Uarge
round hoUein the back, as shown,
SHde the Upright (3) onto the Upright Base (2),
Make sure you do not pinch the Upper Wire
Harnesses (172). Secure the Upright with two
M10 Washers (129), two MIO x 20mm Screws
(113), and two MIO x 25mm Screws (105), Do
not tighten the Screws yet.
Connect the Upper Wire Harness (172) to the
Lower Wire Harness (173) extending from the
Mech Frame (not shown), The connector should
slide easily into the socket and snap into place.
Ufthe connector does not slide easily and snap into
pUace,turn it over and then insert it, IF THE CON-
NECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Press the excess wire
into the Upright Base,
Tighten two M4 x 16mm White ZP Serf-tapping
Screws (159) into the Upright (3),
11, Unsertan MIO x 125mm Button Screw (144)
through an MIO Washer (129), the Upright (3),
and the Backing Hate (not shown), Hold the BoJt
in place by sticking a piece of tape over the
bott head.
Tighten the two MIO NyJon Locknuts (!12}
used in step 7. Tighten the two MIO x 20ram
Screws (113} and two MIO × 25ram Screws
(!05} used in step 10.
Attach the Mech Frame (124) to the Base (1) with
two MIO x 73mm Bolts (137) and two MIO
Washers (129), Do not tighten the Botts yet.
Attach the Mech Frame (124) to the Upright (3)
with the MIO x 125mm Button Screw (144), Make
sure the Upright and Mech Frame are properly
aligned before tighten the Screw.
Tighten the four MIO x 73ram Botts (137} in
the Base (!} and the two M!O Nylon Locknuts
(112} used in the second paragraph of step 2.
Snap the Side Mech Cover (81) into place on the
Mech Frame (124),
10
11
31
Slots on bottom
31
\
129
144
172
159
\
124
129
81
\
137
10