Connections - Pioneer VSX-D704S Operating Instructions Manual

Audio/video stereo receiver
Hide thumbs Also See for VSX-D704S:
Table of Contents

Advertisement

CONNECTIONS
I Setting
Up the AM Antenna
I
• Insert the claw on the bottom of the antenna into the groove
in the leg.
• Place the antenna on a level surface and rotate it to locate
the orientation
that yields the best reception.
• Use the attachment
hole in the leg to screw to a wall or
other location, then insert the claw on the bottom of the
antenna into the groove in the leg (fixing the antenna in the
direction that gives the best reception.)
d wire
Precaution
regarding
installation
position
of cassette deck
If the cassette deck is installed in the @ positions shown in
the drawing
below,
it may be adversely
affected
during
playback. If possible, it's better to install it in the ® position.
®
_
Receiver
®
®
I Installation
Precautions
]
• The rear panel vents are designed to disperse heat from
the unit. Be careful that curtains or other items do not block
the vents.
•To improve heat dispersion, set the unit so that it is at least
20 cm (8 inches) away from the wall.
Atleast 20cm (8 inches)
POWER-CORD
CAUTION
Handle the power cord by the plug. Do not pull out the plug
by tugging the cord and never touch the power cord when
your hands are wet as this could cause a short circuit or an
electric shock. Do not place the unit, a piece of furniture,
etc., on the power cord, or pinch the cord. Never make a
knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped
on. A damaged power cord can cause a fire or give you an
electrical shock. Check the power cord once in a while. When
you find it damaged, ask your nearest PIONEER authorized
service center or your dealer for a replacement.
7
<ARB7035>

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents