Table of Contents
Advertisement
SURROUND
EDIT OPERATION
(GUI OPERATION)
S C
Intelfigent
System Control
* If you press the SURR EDIT button on a function operation
display, display switches to "SURROUND EDIT" indications
for the currently selected surround mode. (Press the EXIT
button to return to the original function operation display.)
• On the SURROUND EDIT display, you can adjust levels,
switch to the center mode, and adjust delay time.
(When
using DOLBY
PRO-LOGIC)
[ SETTING
THE DELAY TIME
J
When using DOLBY PRO-LOGIC SURROUND or SIMULATED
SURROUND, you can set the delay time between 16 ms and
30 ms (2 ms step).
The standard setting is 20ms, but you can select any setting
of your choice.
[ LEVEL ADJUSTMENT
J
Example:When
using DOLBY PRO-LOGIC
1. Press the CENTER MODE button to select the Center
Mode. (Refer to page 6 ) "1
NORMAL -_-
WIDE _
PHANTOM
2. Press the TEST TONE button to switch the test tone
on.
The test tone is output from each of the speakers in the
following order.
*2
---*Front
Left -----*
Center
Surround(Rear)-.-----Front
Right _
3. Adjust so that the volume level is the same from each
of the speakers.
• Use the CENTER LEVEL Jr-, -- buttons to adjust the
center speaker volume level. *3
• Use the REAR LEVEL 4-, -- buttons to adjust the rear
speakers volume level. *4
4. Press the TEST TONE button to switch the test tone
OFF.
NOTE:
"1 You can select the CENTERMODE when
using
DOLBY PRO-
LOGIC SURROUND, PRO-LOGIC THEATERand DOLBY 3CH
LOGIC.
When
using
DOLBY 3CH
LOGIC,
you can switch between
NORMAL and WIDE settings.
*2 When the CENTERMODE button is PHANTOM
position,
no
test
tone is
output
from
the center
speaker.
*3 Only when using DOLBY PRO-LOGICSURROUNDand DOLBY
3CH LOGIC can you adjust the CENTERLEVEL.
*4 When using DOLBY 3CH LOGIC, the REAR speakers are not
used.
33
<ARB7035>
Hide quick links:
Advertisement
Table of Contents
