Rear Panel Facilities - Pioneer VSX-D704S Operating Instructions Manual

REAR PANEL FACILITIES
Illustration shows Multi-voltage model.
(b® ®
I
L?Ij .....
@®@ @@
FM/AM ANTENNA terminals
Use these antenna terminals for reception of normal FM and
AM broadcasts.
CHANNEL STEP switch
(Multi-voltage model only)
See page 4.
® PAL/NTSC switch
(Multi-voltage model only)
Switch to match the color system of the TV set you are using.
® TAPE 2 MONITOR jacks
Connect to audio components such as a second cassette
deck or a graphic equalizer.
PHONO input jacks
Connect to the output cables from a turntable.
(_ GND terminal
Connect the turntable ground lead to this terminal.
@@ @ @ @
9(9@ C ONTROL IN/OUT jacks
VCR 2 jacks
[VIDEO OUT]
Connect to the VCR 2 VIDEO INPUT jack.
[AUDIO OUT (L, R)]
Connect to the VCR 2 AUDIO INPUT jacks.
[VIDEO IN]
Connect to the VCR 2 VIDEO OUTPUT jack.
[AUDIO IN (L, R)]
Connect to the VCR 2 AUDIO OUTPUT jacks.
_8;VIDEO OUT (TO MONITOR TV) jack
Connect to a monitor TV or to TV sets with video input
terminals to watch program materials from a VCR or LD player
connected to this unit.
13
<ARB7035>
1_ SYSTEM CONTROL IR OUT jacks
To operate other components with this unit's remote control
or with GUI, connect the supplied repeater. (See page 12.)
MINI-REPEATER 1, 2
:Connect the supplied Mini-Repeater.
MAIN-REPEATER
:Connect the supplied Main-Repeater.
IN :Connect this jack to other Pioneer components whe_
using those components to control this unit.
OUT :Connect this jack to other Pioneer components when
using the remote control of this unit to control the
other components.
NOTE :
If there is a plug in this unit's CONTROLIN jack, GUIoperation is
not possible.
•
The receiver's remote sensor does not function when
a
plug _s
inserted in the INjack. To operate,point the remote control unit at
the remote sensor on the component to which the receiver's IN
jack is connected. In this case, connect a component featuring
intelligent system control to the IN jack.
CONTROL
[ ,_1 r.... :%
//t PIONEER c°_mp°nent /
bearing the _ mark
Remote
0
V
control unit To the CONTROL IN jack of
the PIONEER component
bearing the _] mark.