Preset Tuning - Pioneer VSX-D704S Operating Instructions Manual

PRESET TUNING
[ FREQUENCY PRESETTING ]
2
3
I LISTENING TO BROADCASTS
PRESET TUNING
1 2 3
. \/ //
IBm: oooooooo:o
USING
Switch off when the GUI MODE button is on.
1. Tune into the desired station.
See the section "TUNING INTO STATIONS".
Inaddition to station frequencies, the MPX MODE (auto stereo
mode or monaural mode) can also be preset (FM only).
2. Press the MEMORY button.
The station (channel) number flashes in the display.
(Memory mode)
3. Turn the MULTI-JOG to select the station (channel)
you want to memorize, and press the ENTER button.
• The station (channel) number lights in the display,
indicating that it has been memorized.
• If you do not press the ENTER button within about five
seconds after selecting a station, the memory mode is
canceled.
4. Repeat steps 1 to 3 to preset additional stations.
A total of 30 AM and FM stations may be preset. When
you store a new preset, it takes the place of the previously
stored station (if any).
You can also preset using GUI. (Refer to page 29.)
Switch off when the GUI MODE button is on.
1. Press the SELECT button.
The "ST CALL" indicator lights in the display, and the
mode switches to station call.
2. Turn the MULTI-JOG to select a station.
3. Adjust the volume and tone as desired.
When operating by remote control, press the ST +/- buttons
to select a memorized station. (Refer to page 27.)
With GUI, you can also select preset channels. (Refer to
page 29.)
NOTE:
Even if the receiver power cord is unplugged, data remains in memory
for several days. If the contents of the memory are erased, preset
once more.
Last station memory
When the POWER switch is pressed to turn the power on,
the last station received before the power was previously
turned off will be tuned in again. When the power is ON, if
the FM/AM button is pressed, the last station received before
the FM/AM button was previously pressed will be tuned in
again.
19
<ARB7035>