Table of Contents
Advertisement
TROUBLESHOOTING
Incorrect
operations
are often mistaken
for trouble
and malfunctions.
If you think that there is something
wrong
with this component,
check
the points
below.
Sometimes
the trouble
may lie in another
component.
Investigate
the other
components
and electrical
appliances
being used. If the trouble
cannot
be rectified
even after exercising
the checks
listed
below,
ask your nearest
PIONEER
authorized service center or your dealer to carry out repair work.
Symptom
Cause
Power
does
not come
on
even
when
the
POWER
switch
is pressed.
Control
is not possible
regardless
of
what
operation button is pressed.
No sound is produced, even
when
the input
selector
button is selected.
No
picture
is produced,
even
when
the
input
selector
button
is selected.
High noise level.
• Power cord is disconnected.
• Instances are rare, but the problem may
be due to the operation of the protector
circuit.
• Static electricity affects the unit when the
air is dry, such as in winter.
• Connections are incorrect.
• The MUTING button is pressed.
• VOLUME is turned down.
• Speaker connecting wires are disconnected
from speaker terminals.
• One or both
of the input
cords
are
disconnected.
• TAPE 2 MONITOR
button is in the ON
position.
• The SPEAKERS button is OFF.
• Connections
are incorrect.
• The selected input selector button are not
correct.
• Station has not been tuned in to correct
frequency.
• Antenna has not been connected or has
become disconnected.
FM reception
• Accessory FM antenna remains bundled
up or it is not pointing in right direction.
• Weak broadcasting station signals.
AM reception
• AM loop antenna is not pointing in right
direction.
• Weak broadcasting station signals.
• Noise is being picked up by this unit from
other equipment
(especially
electrical
appliances
using motors or fluorescent
lights).
Remedy
• Connect cord securely.
• Unplug the power cord of the unit from the
AC wall outlet, then plug it in again.
Unplug the power cord of the unit from the
AC wall outlet, then plug it in again.
• Press the RESET button.
• If static
electricity
is pronounced,
it is
recommended that you operate the unit using
the remote control unit.
• Consult pages 7-12 and perform connections
correctly.
• Press the MUTING
button
to cancel the
MUTING effect.
• Raise volume.
• Connect wires to terminals securely.
• Connect input cords securely.
• Press the button again to the OFF position.
• Switch the SPEAKERS button ON.
• Consult pages 7-12 and perform connections
correctly.
• Press the correct button.
• Tune the station in correctly.
• Connect the antenna securely.
- Stretch both ends of antenna taut and locate
direction yielding optimum reception.
• Replace accessory FM antenna with outdoor
FM antenna.
• Change the direction of the AM loop antenna and
find a position where reception is improved.
• Erect an outdoor AM antenna or connect a
ground wire.
• Turn off the appliances generating noise or
remove them from the vicinity of the stereo
equipment.
• Separate the antenna from the unit by some
distance.
37
<ARB7035>
Hide quick links:
Advertisement
Table of Contents
