Pioneer VSX-D704S Operating Instructions Manual page 35

REMOTE SET UP (GUI OPERATION)
]_ C" Intelligent
System Control
l Learning
]
Pioneer remote control commands are in the non-preset gray
buttons, but you can use them to learn remote control signals
from your component's remote control.
1. Perform the first three steps of "Calling up and setting
up presets".
2.
Select the gray button you want to use for learning
and press.
The "STANDBY" indication flashes. (If you remain in
STANDBY for about 1 minutes, it is canceled.)
(Example: Using the 0 buttons for learning)
NOTE:
• To return buttons you used for learning to their onginal settings,
press the CLEAR button. This returns them to the original Pioneer
remote control commands.
• There are no signals in buttons I, #, and _, so you can use
them for learning.
• Even when OK is indicated during learning, operation may still not
be possible. If this happens, repeat the learning procedure. With
some manufacturers' components, leamig may be difficult to
perform. Learning may also not be possible if the remote control's
batteries are run down. If this is the case, load the remote control
with new batteries and repeat the learning procedure.
• Even black preset buttons can be used for learning other
commands.
• Learning a command may not be possible if many commands
requiring a large amount of memory have already been learned
resulting in insuffecient memory remaining.
3,
Point your component's l e==lute _untrol at this unit's
remote sensor window and press the selected button.
/ _ VSX-D704S
,-,
_ Press, holding the remote control
_ unit within 50 cm of this unit's
I_ _ sensor window.
• If "OK" is displayed, learning has been completed. If
you want to use another button for learning, repeat
steps 2 and 3.
• If "NG" is displayed, rcpuat step,') 2 and 3.
• When you have completed learning, press the EXIT
button.
35
*.AHB7035>