Table of Contents
Advertisement
SURROUND MODE
This unit is equipped with DOLBY PRO LOGIC SURROUND. There's also
a DSP (Digital Signal Processor), with a choice of five SFC (Sound Field
Control) simulated surround settings.
e JAZZ:
This gives you the sound field of a jazz club.
© DANCE:
A "hot" high-energy sound, with extra reverb for greater ambience.
© CHURCH:
The sound field of a church, ideal for reproducing the rich sound of a
pipe organ.
¢ HALL:
You can enjoy a convincing hall sound.
© THEATER:
Use this when watching movie sources that have a stereo soundtrack
to enjoy the effect of being in a movie theater. It is also effective when
used with video software bearing the
pig)
mark.
{It cannot be used simultaneously with DOLBY PRO LOGIC SURROUND
or DOLBY 3CH LOGIC.)
* DOLBY PRO LOGIC SURROUND
Choose this setting for movies and music (especially Video Discs and
video tapes bearing the
pie
mark) playback.
DOLBY PRO LOGIC SURROUND
continuously detects the size and
direction of the dominant signal and cancels undesirable crosstalk,
thereby providing signal emphasis.
You can clearly perceive the directions and source of the music.
Real flow of sound also can be re-created naturally using this feature.
It gives the feeling of being in an outstanding and expansive sound field.
When using DOLBY PRO LOGIC SURROUND, a delay time setting of
20 ms is commonly used. Use a different setting if you prefer.
¢ DOLBY 3 CH LOGIC
By adding the signal for the rear speakers to the signal for the front
speakers, the front three channels (front L, front R, and CENTER) provide
a much wider, more spacious sound field than possible during ordinary
stereo playback.
DOLBY
PRO
LOGIC
SURROUND
is equipped
with the following
3 positions for the CENTER MODE.
When using DOLBY 3 CH LOGIC, you can select NORMAL or WIDE.
When using center speaker:
¢ NORMAL
Low range frequencies, which have little effect on directionality and
positioning, are routed to the left and right front speakers. So you can
use relatively small size speakers as the center speakers.
« WIDE
if you use large size center speaker, choose this setting. The full
frequency range of the center speakers, from low to high, is routed to
the center speaker.
When not using a center speaker: DOLBY PRO LOGIC SURROUND
¢ PHANTOM
The signal which would have been sent to the center speaker is divided
equally between the left and right front speakers.
SURROUND SPEAKER INSTALLATION EXAMPLE
To get the best effect out of the surround system, place the speakers
as shown
below.
An example for center speaker location
When using a center speaker
FRONT
FRONT
err
|
RIGHT
SPEAKER
CENTER SPEAKER
SPEAKER
FRONT
Listening area
RE
REAR
an
REAR
LEFT
RIGHT
SPEAKER YY
® SPEAKER
celta
EEO
oR
er SEE
6
<ARB1371>
NOTE:
© To avoid interference with the picture on a nearby TV set, use
magnetically shielded speaker systems. This is particularly important
for the center speaker since it is usually located closest to the TV.
*® Position the left and right channel speakers at equal distances from
the TV set and approximately six feet from each other.
© Position the center speaker above, below, or behind the TV set. Sound
may not appear to coincide with the picture if you position it next to
'the TV set.
© Rear speakers are best positioned slightly above ear level.
Manufactured under license from Dolby Laboratories Licensing
Corporation.
Additionally licensed under one or more
of the
following patents: U.S. numbers
3,632,886,
3,746,792 and
3,959,590;
CANADA
numbers
1,004,603
and
1,037,877.
"Dolby" and the double-D
[]{] symbol are trademarks of Dolby
Laboratories Licensing Corporation.
Manufacturé
sous
licence
de
Dolby
Laboratories
Licensing
Corporation. En outre, sous license d'un ou plusiers des brevets
suivants:
numéros
américains
3,632,886,
3,746,792
et
3,959,590; numéros canadiens
1,004,603
et 1,037,877. Le
terme ''Dolby"' et le symbole Double-D
Do
sont des marques
dépsoées de Dolby Laboratories Licensing Corporation.
Note:
DOLBY PRO LOGIC SURROUND and DOLBY 3CH LOGIC will not
operate correctly if the signal passes through a graphic equalizer.
When using DOLBY PRO LOGIC SURROUND or DOLBY 3CH LOGIC,
turn off the TAPE 2 switch or set the graphic equalizer for flat
Wrens or to its ''through'' (defeat or off} setting, if it has one.
Advertisement
Table of Contents
