Surround Edit Operation (Gu! Operation) - Pioneer VSX-604S Operating Instructions Manual

¢ If you press the SURR EDIT button on a function operation
display, display switches to "SURROUND EDIT" indications
for the currently selected surround mode. (Press the EXIT
button to return to the original function operation display.)
* On the SURROUND EDIT display, you can adjust levels,
switch to the center mode, and adjust delay time.
(When using DOLBY PRO-LOGIC)
LEVEL ADJUSTMENT
Example:When using DOLBY PRO-LOGIC
1. Press the CENTER MODE button to select the Center
Mode. (Refer to page 6 ) *1
(— NORMAL —+ WIDE — PHANTOM —
2. Press the TEST TONE button to switch the test tone
on.
The test tone is output from each of the speakers in the
following order. ;
Front Left ——» Center
Surround(Rear) <——Front Right _
3. Adjust so that the volume level is the same from each
of the speakers.
» Use the CENTER LEVEL + , — buttons to adjust the
center speaker volume level. *3
+ Use the REAR LEVEL +, — buttons to adjust the rear
speakers volume level. *4 :
4. Press the TEST TONE button to switch the test tone
OFF.
NOTE:
*1 You can select the CENTER MODE when using DOLBY PRO-
LOGIC SURROUND and DOLBY 3CH LOGIC.
When using DOLBY 3CH LOGIC, you can switch between
NORMAL and WIDE settings.
*2 When the CENTER MODE button is PHANTOM position, no test
tone is output from the center speaker.
*3 Only when using DOLBY PRO-LOGIC SURROUND and DOLBY
3CH LOGIC, can you adjust the CENTER LEVEL.
*4 When using DOLBY 3CH LOGIC, the REAR speakers are not
used.
28
<ARB7022>
SURROUND EDIT OPERATION (cut operation)
I S Intelligent
System Control
| SETTING THE DELAY TIME
15ms+—*>20ms+—+>25ms*—30ms