The LS-HB Ultra primary projection lens is shipped separately from the projector. Proceed
as follows to install it:
1. Using a Phillips
screwdriver, remove the
two screws holding the
projector front cover in
place.
2. Gently pull the cover away from the projector at
each side to detach it.
3. Remove the cover and set it aside.
4. Remove the foam plug from the lens cavity.
Runco LS-HB/LS-HB Ultra Installation/Operation Manual
21
Installation
3.4
Installing the Primary
Projection Lens
(LS-HB Ultra only)
Removing the Projector
Front Cover