Table 3-1 gives a quick overview of the LS-HB installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install primary projection lens
2
3
Install anamorphic lens mounting assembly (optional)
Mount the projector
4
Connect signal sources to the LS-HB
5
Connect external controller to RS-232 port and/or IR repeater
6
system (optional)
Connect 12-volt trigger output to retractable screen or other,
7
+12V trigger-activated equipment (optional)
8
Apply power to the projector
Primary lens adjustments: projected image size (zoom), position
9
(shift) and focus
Change the OSD Language (optional)
10
For rear-screen and/or ceiling-mount installations, select the
11
proper picture orientation
Install and adjust secondary anamorphic lens (optional)
12
Projector calibration: adjust the following for each input; save
settings when finished:
• Aspect ratio
• Brightness
13
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
Runco LS-HB/LS-HB Ultra Installation/Operation Manual
Procedure
For Details, Refer
to page...
16
21
24
30
33
38
39
40
19, 41
42
42
43
50
15
Installation
3.2
Quick Setup