Runco LightStyle LS-HB Installation & Operation Manual page 81

Source Enable: To enable or disable selection of a source, choose Source Enable from
the System menu and press ENTER. This displays the Source Enable sub-menu, shown
in Figure 4-12.
Figure 4-12. Source Enable Sub-Menu
• HDMI 1/HDMI 2: Enables or disables the HDMI 1 and HDMI 2 sources.
• RGB: Enables or disables the RGB source.
• Comp 1: Enables or disables the Component 1 source.
• Video: Enables or disables the Composite video source.
If either Component 1 or Video is enabled, SCART must be disabled.
Note
• S-Video: Enables or disables the S-Video source.
• SCART: Enables or disables the SCART RGBS source.
If SCART is enabled, both Component 1 and Video must be disabled.
Note
Runco LS-HB/LS-HB Ultra Installation/Operation Manual 65
Operation