Table of Contents
Advertisement
Installation
3.7
Connections to the
LS-HB
Connector Panel Access
Proceed as follows to connect the LS-HB to your video sources, external controller(s) – if
present – and AC power.
When connecting your equipment:
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.
Then, remove the rear compartment cover by
tilting it upward.
32
Runco LS-HB/LS-HB Ultra Installation/Operation Manual
Advertisement
Table of Contents
Troubleshooting
