Installation; Remote Control; Notes On Batteries; Notes On Remote Control Operation - Runco LightStyle LS-HB Installation & Operation Manual

To install batteries in the remote control:
1. Slide the battery compartment cover in the direction of the arrow to remove it.
2. Install two AA batteries with the correct polarity.
3. Replace the cover.
1.
• Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
• Do not expose batteries to excessive heat such as from sunshine, fire or the like.
• In most situations, you can simply point the remote control at the screen which will
reflect the IR signal from the remote back toward the IR receiver on the projector. In
some cases, however, ambient conditions may prevent this. If so, point the remote
control at the projector and try again.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
Runco LS-HB/LS-HB Ultra Installation/Operation Manual
2.
3.
13

3. Installation

3.1

Remote Control

Notes on Batteries

Notes on Remote Control
Operation
Installation