Operations Commands - Runco LightStyle LS-HB Installation & Operation Manual

Serial Communications

Operations Commands

Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232
Remote Button
Keyname
asp.4.3
(none)
asp.lett
(none)
asp.narr
(none)
pip.sw
PIP
pip.1
(none)
pip.2
(none)
pip.3
(none)
pip.4
(none)
pip.5
(none)
pip.off
(none)
pip.swap
SWAP
pow.tog
(none)
lit.tog
LIGHT
Operations commands allow more flexible and direct control of the projector. The syntax
for operations commands is as follows:
op <operation> <command>[CR]
(Precede <operation> and <command> with a space.)
The command type can be one of 5 functions:
Operations Control Commands
Function Command
= <value>
Set
Get
Increment
Decrement
(none)
Execute
IR Code
Set 1 Set 2
0x9F 0xDF Apply 4:3 aspect ratio to the active source.
0xA0 0xE0 Apply Letterbox aspect ratio to the active
source.
0xA1 0xE1 Apply 4:3 Narrow aspect ratio to the active
source.
0xA3 0xE3 Switch to next "PIP Select" state.
0xA4 0xE4 Change "PIP Select" to source 1.
0xA5 0xE5 Change "PIP Select" to source 2.
0xA6 0xE6 Change "PIP Select" to source 3.
0xA7 0xE7 Change "PIP Select" to source 4.
0xA8 0xE8 Change "PIP Select" to source 5.
0xA9 0xE9 Change "PIP Select" to off.
0xAA 0xEA Swap the PIP image with the active source
image.
0xAC 0xEC Toggles between power on and power off.
0xAD 0xED Activates remote backlighting only when
pressed momentarily. When held for five
seconds or more, the IR code for toggling
the projector I/O panel light is transmitted.
Action on unit
Makes the unit take that value.
?
Asks what the current value is.
+
Adds 1 to the current value.
-
Subtracts 1 from the current value.
Performs an action such as a reset.
80 Runco LS-HB/LS-HB Ultra Installation/Operation Manual
Description