Connecting An External Ir Receiver; Connecting To Ac Power - Runco LightStyle LS-HB Installation & Operation Manual

Installation
Connecting an External IR
Receiver

Connecting to AC Power

If infrared signals from the remote control cannot reach the projector due to excessive
distance or obstructions such as walls or cabinet doors, you can connect an external IR
repeater system to the IR INPUT on the LS-HB to extend the range of the remote control.
See Figure 3-15.
(3.5-mm, mini
phono plug)
TRIGGER TRIGGER 12V 12V
RS RS
INPUT IR
12V TRIGGER 12V TRIGGER
232 232
IR INPUT
S-VIDEO S-VIDEO
S-VIDEO S-VIDEO
Figure 3-15. External IR Receiver Connection
Projector: Plug the female end of the power cord into the AC receptacle on the rear of
the projector (AC 100V ~ 240V); see Figure 2-3. Then, connect the other end to your AC
power source.
Anamorphic Lens Transport: An
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
IR Sensor
IR Repeater
VIDEO VIDEO
SCART SCART - - COMPONENT1 COMPONENT1
COMPONENT1 - SCART COMPONENT1 - SCART
VIDEO VIDEO
40 Runco LS-HB/LS-HB Ultra Installation/Operation Manual
Remote Control