Programmed Scan - Icom IC-V80 Instruction Manual

Previous view
7
SCAN OPERATION

■ Programmed scan

Repeatedly scans between two programmed frequen-
cies (memory channels "xA" and "xb"). Used to check
for frequencies within a specifi ed range, such as re-
peater output frequencies, and so on. 3 pairs of scan
edges are programmable.
Scan edge channels, 1A/b, 2A,b and 3A/b must be pro-
grammed in advance.
D Programming scan edge channels
q Push [VFO/MR/CALL] several times to select the
VFO mode.
w Set the desired frequency.
e Push [FUNC](M), and then push [VFO/MR/CALL].
• "X" and the memory channel number blink.
r Push [Y] or [Z] to select a scan edge channel
("xA").
t Push [FUNC](M), and then hold down [VFO/MR/CALL]
for 1 second to save the entry.
• 3 beeps sound.
y In same way, program another scan edge channel
("xb").
NOTE: To cancel programming, push [VFO/MR/CALL]
before storing the entry in step t.
D Starting a programmed scan
q Push [VFO/MR/CALL] several times to select the
VFO mode.
w Push [FUNC](M), and then push [SCAN](5) to start
the scan.
e During the scan, push [FUNC](M), and then push
[SET](8) several times to select either the "P1," "P2"
or "P3" scan.
• "P1," "P2" and "P3" for programmed scan between the
programmed scan edge channels.
• To change the scan direction, push [Y] or [Z].
r To cancel the scan, push any key except [ ], [Y]/
[Z], [MONI] or [FUNC](M).
NOTE: Scan edge channels, 1A/b, 2A/b and 3A/b
must be programmed in advance. Program them in
the same manner as regular memory channels.
If identical frequencies are programmed into the
scan edge channels, the programmed scan will not
function.
[i.e.]: Programming 145.300 MHz into scan edge 1A.
Set the frequency.
Push , and then push
Push or to select channel 1A.
Push , and then hold down
Automatically returns to the VFO mode.
[i.e.]: Starting a scan between edge channels 1A and 1b.
Push , and then push
If necessary, push , and then push
to select the scan type "P1."
27
(VFO mode)
.
for 1 second.
. (A scan starts)
(VFO mode)
several times