Set Modes - Icom IC-V80 Instruction Manual

Previous view
10

SET MODES

D Microphone simple mode
Microphone Simple mode is used to assign the essential
operations to the four switches (S1 to S4) on the remote
control unit.
• mS .Sm
S1 Selects the Call channel.
S2 Turns the Monitor function ON or OFF.
S3 Selects memory channel 0.
S4 Selects memory channel 1.
• mS .n1 (default)
S1 Toggles the VFO mode and the memory mode.
S2 Selects the Call channel.
S3 Frequency or memory channel up.
S4 Frequency or memory channel down.
• mS .n2
S1 Toggles the VFO mode and the memory mode.
S2 Turns the Monitor function ON or OFF.
S3 Frequency or memory channel up.
S4 Frequency or memory channel down.
• User remote control unit
The circuit illustrated below is for only reference.
2.7kΩ 6.8kΩ 15kΩ 33kΩ
S1 S2 S3 S4
to the [SP] jack
REMOTE
3.5(d) mm
SP
+
GND
–
EXTERNAL SPEAKER
Ω)
Rated input > ‗ 700 mW (8
D Voltage display
The voltage of the battery is displayed at power ON.
This display can be turned ON or OFF.
• VLt.OF : The battery voltage display is skipped.
• VLt.On : The battery voltage is displayed at power ON. (default)
D Battery protection
When the battery voltage decreases, the Battery Pro-
tection function automatically turns OFF the transceiv-
er. Select the function option according to your battery
type. (default: differs depending on the version)
• bAt.OF : Turns OFF the function. Select when you use the
BP-263 battery case.
• bAt.nm : Select when you use the BP-264 Ni-MH battery
pack.
• bAt.LI : Select when you use the BP-265 Li-ion battery pack.
NOTE: BE SURE to select an appropriate option accord-
ing to your battery type.
D Auto low power
Turns the Automatic Low-power function ON or OFF.
When the temperature goes below 0°C (+32°F), the function
automatically sets the output power to low. In that case, the
transmit power selections (Hi or Mid) are also disabled.
D Squelch burst
The squelch burst function stops transmitting a subaudible tone be-
fore your transceiver stops transmitting RF, to eliminate noise. The
squelch burst will be effective only when the other station uses the
tone squelch function.
• Sqb.OF : The squelch burst is OFF. (default)
• Sqb.On : The squelch burst is ON.
44
Only IC-U80/IC-U80E
(default: ALP.OF)
Only IC-U80/IC-U80E