D Power Save; Lcd Contrast - Icom IC-V80 Instruction Manual

Previous view
10
SET MODES
D Dial assignment
Selects whether or not to use [VOL] as a tuning con-
trol or channel selector, instead of [Y] and [Z]. When
[VOL] functions as a tuning control or channel selector,
[Y] and [Z] function as volume controls.
Option [VOL]
tOP.VO Volume control
tOP.di Tuning control
D Display type
Set the display type for memory mode operation.
• dSP.FR : Displays the programmed frequency. (default)
• dSP.CH : Displays only the memory channel number.
NOTE: Only the following functions can be used.
• Scan function (p. 26)
• Setting output power (p. 15)
• DTMF Memory function (p. 33)
• Key Lock function (p. 15)
• Setting of following items in the Set mode (p. 36)
• Setting of following items in the Set mode
The scan resume, function key timer, LCD back-
light, VOX-related settings, microphone gain and
DTMF TX key.
• dSP.nm : Displays the channel name.
If no memory name is programmed, the pro-
grammed frequency will be displayed.
D LCD contrast
Selects the LCD contrast.
• Lcd.LO : Sets the contrast to low.
• Lcd.At : Sets the contrast to high. (default)
However, if the transceiver is exposed to high tem-
peratures, it automatically sets the contrast to low.

D Power save

The Power Save function allows you to conserve battery
life by selecting the duty cycle of the receiver. Select the
ratio of the power save time to the standby time.
To turn OFF the function, select "P–S.OF."
• P–S.OF : Turns OFF the function.
[Y]/[Z]
• P–S. 2
Tuning controls
• P–S. 8
Volume controls
• P–S.16 : Sets the duty cycle to 1:16.
• P–S.At
D Dial acceleration
Selects whether or not to accelerate the turning speed
when rotating [VOL] rapidly.
• S–S. m : Turns OFF the tuning speed acceleration.
• S–S. At : The turning speed is automatically accelerated
43
: Sets the duty cycle to 1:2.
(ON: 0.1 second, OFF: 0.2 seconds)
: Sets the duty cycle to 1:8.
(ON: 0.1 second, OFF: 0.8 seconds)
(ON: 0.1 second, OFF: 1.6 seconds)
: Automatically sets the duty cycle. (default)
When no operation occurs and no signal is re-
ceived for 5 seconds, the transceiver enters the
Power Save mode, and sets "1:2" as the duty
cycle, and after 60 seconds, it sets "1:16" as the
duty cycle.
when rapidly rotating [VOL]. (default)